Yamame110's Method to Prevent Tenkara Rod Sticking


(David Walker) #1

テンカラ竿の固着防止
Prevention of tenkara rod sticking

I’ve not tried this. But only once have I had a little trouble getting a rod to collapse.

His blog also often has interesting things. His 3 main interest seem to be Tenkara Fishing, Tanago Fishing and His Honda Cub.

http://yamame110.ldblog.jp/

See the category list at top right side to filter entries
カテゴリー Category
テンカラ釣り (103) Tenkara Fishing
タナゴ釣り (153) Tanago Fishing
ハンターカブ (82) Honda or Hunter Cub
Mostly is see Honda Cub written as ホンダーカブ, but maybe the Honda Cub 110 is also called the Hunter. However, it’s an early model Trials motorcycle at the top of the page.


(David S Riley) #2

Thank you David. The tip to prevent sticking is very useful and does work well. Until your post I had forgotten all about it. When I bought my first carbon fly rod in the early 1970s it was the practice to rub the male joint with a candle to prevent sticking. I did that for years and never had any rod sticking. I must start doing that again.

David


(David Walker) #3

:joy: That it reminded you of past effective practice.


(Nick Pavlovski) #4

So, putting a little candlewax is really safe? Are there any rodmakers here who will verify? I can’t sfford to ruin my rods!


(David S Riley) #5

Nick

Have a look at these links,

http://www.sageflyfish.com/equipment-care

If you do a website search you will find many references to anglers carrying a piece of candle wax with them to wax the joints. If you follow the link above to Sage’s site you will see they make reference to the use of candle wax. I think that should put your mind at rest should you decide to wax your tenkara rods with candle wax.

David


(Nick Pavlovski) #6

Thank you David, that’s wonderful, I think I’ll be seeking out some paraffin next time I’m at a hardware shop.


(Anthony Naples) #7

I would worry a little that grit might stick to the wax - I’ve been warned that some little bit of grit at the joint can cause failure of tenkara rods at the joint due to stress from improper seating of the joint.

I cannot verify that this would be the case - but it’s a thought that I have regarding adding anything to the rod


(Nick Pavlovski) #8

That’s a fair observation…not to let grit/sand/dirt get inside the tubes and cause scouring or jamming of joints…hmmm.